OMAFRA report

A weekly report prepared by the staff of the Ministry of Agriculture, Food and Rural Affairs (OMAFRA). If you require further information, regarding this report, call the Elora Resource Centre at 519-846-0941.  Office hours: 8:30am to 4:30pm.  For technical information, call the Agricultural Information Contact Centre at 1-877-424-1300 or visit the OMAFRA website: www.ontario.ca/omafra

Storing wet corn safely

Many grain farmers may have questions about storing and drying corn this year, with recent propane shortages and a lot of wet corn still in the field.

Decisions for harvesting corn will vary from farm to farm based on local conditions and factors (corn moisture, distance to alternative dryers, crop standability).

Some farmers may already have harvested wet grain and now are unable to dry it.

Wet corn can be safely stored for short periods of time, depending on the moisture level and temperature of the grain. This is a short-term solution and is not recommended for very wet grain (e.g. above 25% moisture).

It is very important to understand that allowable storage time does not “reset” when corn is dried.

Follow these steps to reduce the risk of wet corn spoiling while in storage:

1. Measure the corn moisture before storage. Estimate the safe storage length at that moisture and at the coldest reasonable temperature give current weather conditions.

2. Ensure the corn is high quality and free from significant damage. Clean the corn if necessary to remove broken kernels, fines and foreign materials.

3. Put the corn into a storage bin equipped with a full aeration floor and aeration fans of reasonable capacity (at least 1/2 CFM of fan airflow per bushel of grain in the bin is recommended).  If fan capacity is small, increase the effective airflow per bushel by filling the bin less full (i.e. fewer bushels in the bin)

4. If possible, use a storage bin with a grain temperature and moisture monitoring system installed.

5. Keep track of the date the bin was filled.

6. Core the bin after filling to remove fines, which tend to collect in the centre as the bin is filled.

7. Level the bin after coring. This ensures consistent airflow through the grain mass for better aeration.

8. As soon as the bin is cored and leveled, run the aeration fans to cool the grain down and minimize any hot spots. At 1/2 CFM airflow per bushel, cooling will take approximately 40 hours. Monitor the grain temperature at the top of the bin to check when cooling has completed (this grain will be the last to cool down).

9. Run aeration fans at night when the coldest temperatures occur.

10. Aerate bins at least 24 total hours each week, to maintain cold temperatures. Left alone, wet grain can begin to heat spontaneously which accelerates spoilage.

11. Monitor grain weekly looking for hot spots, visual spoilage, off-odours and any other signs of spoilage. Use bin temperature and moisture monitoring systems if available.

12. Remove the grain from storage once 60 to 70% of the allowable storage time has elapsed and send it for drying or other uses. Once the corn has been dried, sufficient storage time will remain to store safely for a reasonable period. For lower quality corn, store no longer than 30 to 40% of the allowable storage time.

Storing wet corn for short periods can be done but requires close management. It can provide brief relief from a drying backlog but should be done carefully, and only once the risks are fully understood.

For more information on aeration, see OMAFRA’s “Grain Aeration” factsheet: http://www.omafra.gov.on.ca/english/engineer/facts/15-039.htm

For full article with charts and illustrations, visit https://fieldcropnews.com/2019/11/storing-wet-corn-safely/.

Written on November 22, 2019 by James Dyck, Engineering Specialist, Crop Systems and Environment, OMAFRA.

Comments